Preface
This is the second edition of CSA Z245.30, Field-applied external coatings for steel pipeline systems. It supersedes the previous edition published in 2014.
The major changes to this edition are the following:
a) the competency requirements have been extensively revised (Clause 6.1);
b) the inspection and testing requirements have been revised (Clause 7);
c) the markings requirements have been revised (Clause 9);
d) the test procedures have been revised (Clause 12); and
e) all tables have been extensively revised.
In this 2018 edition, where a major change or addition to the previous edition of this Standard has been made, the clause, table, or figure affected is identified by the symbol in the margin. Users of this Standard are advised that the change markers in the text are not intended to be all-inclusive and are provided as a convenience only; such markers cannot constitute a comprehensive guide to the revisions made to this Standard. Care must therefore be taken not to rely on the change markers to determine the current requirements of this Standard. As always, users of this Standard must consider the entire Standard.
This Standard was prepared by the Subcommittee on Coatings, under the jurisdiction of the Technical Committee on Petroleum and Natural Gas Industry Pipeline Systems and Materials and the Strategic Steering Committee on Petroleum and Natural Gas Industry Systems, and has been formally approved by the Technical Committee.
Scope
1.1
This Standard covers the qualification, application, inspection, testing, handling, and storage of materials required for coatings applied externally to steel piping in the field or a shop. Coated piping addressed by this Standard is intended primarily for buried or submerged service in oil or gas pipeline systems.
1.2
This Standard covers the following coating systems:
a) System FC1: liquid-applied epoxy or fusion bond epoxy (FBE) with a glass transition temperature of 115 °C or less;
b) System FC2: liquid-applied epoxy or FBE with a glass transition temperature greater than 115 °C;
c) System FC3: liquid-applied epoxy or FBE intended for abrasion service;
d) System FC4: adhesive and a polymeric backing (e.g., tape, heat shrinkable sleeve);
e) System FC5: epoxy primer, adhesive, and a polymeric backing (e.g., tape, heat shrinkable sleeve);
f) System FC6: anti-corrosion coating, if applicable [see Items a), b), d), and e)], polyurethane foam insulation, and a polymeric backing with or without adhesive (e.g., tape, heat shrinkable sleeve); and
g) System FC7: fibre-reinforced petrolatum, paraffin-filled, or visco-elastic systems.
1.3
In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the Standard.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written as requirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.
