COVERAGE:

Commercial, industrial, institutional or household
pressurized flushing devices (PFDs) of the tank (flushometer tank) and non-tank
(flushometer valve) types. These devices are attached to a pressurized water
supply pipe that, when actuated, opens the pipe for direct flow of water into
the fixture at a rate and in a quantity that enables proper operation of the
fixture. The valve then gradually closes to provide trap reseal in the fixture
and avoid water hammer. Tank type PFDs are attached to a pressurized water
supply pipe but integrated within an accumulator vessel affixed and adjacent to
the fixture inlet to cause an effective enlargement of the supply line.

REQUIREMENTS:

MARKING:

PFDs complying with this Standard shall be marked
with:

• the manufacturer’s name, trademark, or other mark
• in the case of private labeling, the name, trademark, or other mark of
  the customer for whom the fitting was manufactured
• CSA Mark
• Flushometer valves equipped with a vacuum breaker shall be permanently
  marked with a line and "CL" to indicate the critical level. (The equivalent
  French wording is "NC")
• identification of flush modes on the actuator of manually activated dual
  flush function PFDs

The marking method consists of casting or stamping
into the body of the fitting, electro etching on trim, or an equally permanent
marking applied at the factory. Where a label is used, it shall be a CSA listed
Type B label.

All marking required by CSA must be permanent,
legible, and visible after installation of the fitting.

PACKAGING:

Packages shall be marked with:

• the manufacturer’s name, trademark, or other mark
• in the case of private labeling, the name, trademark, or other mark of
  the customer for whom the fitting was manufactured
• the model name or series number
• the water consumption in liters per flush (Lpf) and gallons per flush (gpf)

INSTALLATION INSTRUCTIONS:

Installation instructions shall be provided with each
unit, including the identification of the specific types of backflow prevention
required when a backflow preventer is not incorporated in the PFD.

Products shall be installed in Accordance with the
Local Code of the Authority Having Jurisdiction.

/cl