Preface
This is the sixth edition of CSA Z245.11, Steel fittings. It supersedes the previous editions published in 2005, 2001, 1996, 1991, and 1985.
Scope
1.1
General This Standard covers wrought steel buttwelding fittings, including extruded headers and factory-produced bends, primarily intended for use in oil or gas pipeline systems.
1.2
Size, grade, and category
1.2.1
Size This Standard covers fittings in sizes from NPS 1/2 to NPS 60. (See Table A.1.)
1.2.2
Grade For other than sour service, this Standard covers fittings from Grade 207 to Grade 690. For sour service, this Standard covers fittings from Grade 207 to Grade 483. Note: The standard grades are Grades 207, 241, 290, 317, 359, 386, 414, 448, 483, 550, 620, and 690 (see Table 1); however, intermediate grades are also permitted.
1.2.3
Category This Standard covers fittings in the following categories: (a) Category I: fittings without requirements for proven notch-toughness properties; and (b) Category II: fittings with requirements for proven notch-toughness properties.
1.3
Assemblies This Standard does not cover assemblies. Note: An assembly means a grouping of fittings or flanges, or both, joined by one or more circumferential welds.
1.4
Terminology In CSA Standards, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; should is used to express a recommendation or that which is advised but not required; may is used to express an option or that which is permissible within the limits of the standard; and can is used to express possibility or capability.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written as requirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to
