Identification cards — Physical characteristics (Adopted ISO/IEC 7810:2019, fourth edition, 2019-12)
Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the SCC Mirror Committee (SMC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T).
This Standard supersedes CSA ISO/IEC 7810:04 (adopted ISO/IEC 7810:2003). At the time of publication, ISO/IEC 7810:2019 is available from ISO and IEC in English only. CSA Group will publish the French version when it becomes available from ISO and IEC.
This Standard has been formally approved, without modification, by the Technical Committee and has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group.
This document describes the characteristics for identification cards and the use of such cards for international interchange.
This document specifies the physical characteristics of identification cards including card materials, construction, characteristics and dimensions for four sizes of cards.
ISO/IEC 10373-1 and ISO/IEC 24789-2 specify the test procedures used to check cards against the parameters specified in this document.
This document specifies the requirements for cards and card interface devices used for identification. It takes into consideration both human and machine aspects and states minimum requirements.
It is the purpose of this document to provide criteria for the performance of cards. No consideration is given within this document to the amount of use, if any, experienced by the card prior to test.
NOTE 1 Numeric values in the SI and/or Imperial measurement system in this document have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system can be used, but intermixing or reconverting the two can result in errors. The original design was made using the Imperial measurement system.
NOTE 2 Thin flexible cards are not within the scope of this document (see the ISO/IEC 15457 series).
Identification Cards - Physical Characteristics (Adopted ISO/IEC 7810:2003, third edition, 2003-11-01)