CSA B45.12-13/IAPMO Z402-2013 (R2018)
Aluminum and copper plumbing fixtures
This is the first edition of CSA B45.12/IAPMO Z402, Aluminum and copper plumbing fixtures.
This Standard supersedes IAPMO IGC 194-2004a, Copper Alloy or Aluminum Alloy Sinks and Lavatories, and IAPMO IGC 217-2011e1, Metallic bathtubs, shower pans, and whirlpool bathtubs.
This Standard was prepared by the CSA/IAPMO Harmonization Task Group on Plumbing Fixtures, under the jurisdiction of the CSA Technical Committee on Plumbing Fixtures and the IAPMO Plumbing Standards Committee. The CSA Technical Committee operates under the jurisdiction of the CSA Strategic Steering Committee on Construction and Civil Infrastructure. This Standard has been formally approved by the CSA Technical Committee and the IAPMO Standards Committee. This Standard was approved as an American National Standard by the American National Standards Institute on December 5, 2013.
This Standard covers aluminum and copper plumbing fixtures and specifies requirements for materials, construction, performance, testing, and markings of these fixtures.
This Standard covers the following plumbing fixtures:
(a) bathtubs and combination tub/showers;
(c) shower bases and shower stalls; and
(i) bar sinks;
(ii) kitchen sinks;
(iii) laundry sinks;
(iv) service sinks; and
(v) drinking fountains.
In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the standard.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written as requirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.
SI units are the units of record in Canada. In this Standard, the inch/pound units are shown in parentheses. The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard.
All references to gallons are to U.S. gallons.
For information on the conversion criteria used in this Standard, see Annex A.