Preface
This is the fourth edition of ASME A112.19.2/CSA B45.1, Ceramic plumbing fixtures. It supersedes the previous editions published in 2018, 2013, and 2008.
This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard.
This Standard was approved by the CSA Technical Committee on Plumbing Fixtures, under the jurisdiction of the CSA Strategic Steering Committee on Construction and Civil Infrastructure and the ASME Standards Committee on Plumbing Materials and Equipment.
This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group.
This Standard has been approved by the American National Standards Institute (ANSI) as an American National Standard.
Scope
1.1 Inclusions
This Standard covers vitreous and non-vitreous china plumbing fixtures, and specifies requirements for materials, construction, performance, testing, and markings.
This Standard’s performance requirements and test procedures apply to all types of water closets and urinals that discharge into gravity drainage systems in permanent buildings and structures, independent of occupancy.
This Standard covers the following plumbing fixtures:
a) bathtubs;
b) bidets;
c) drinking fountains;
d) fixtures for institutional applications;
e) lavatories;
f) shower bases;
g) sinks including
i) bar sinks;
ii) clinic sinks;
iii) kitchen sinks;
iv) laboratory sinks;
v) laundry sinks;
vi) service sinks; and
vii) utility sinks;
h) urinals; and
i) water closets.
1.2 Terminology
In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; should is used to express a recommendation or that which is advised but not required; may is used to express an option or that which is permissible within the limits of the Standard; and can is used to express possibility or capability.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written as requirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.
1.3 Units
SI units are the units of record in Canada. In this Standard, the yard/pound units are shown in parentheses. The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard.
All references to gallons are to U.S. gallons.
Note: See Annex B for information on the unit conversion criteria used in this Standard