Codes & Standards - Subscribe
CAN/CSA-C22.2 NO. 62841-3-13:18 (R2023)
This is the harmonized CSA Group and UL Standard For Electric Motor-Operated Hand-Held Tools, Transportable Tools And Lawn And Garden Machinery – Safety – Part 3-13: Particular Requirements for Transportable Drills. It is the First edition of CAN/CSA-C22.2 No. 62841-3-13 and the First edition of UL 62841-3-13.
This harmonized standard is based on IEC Publication 62841-3-13: First edition Electric Motor-Operated Hand-Held Tools, Transportable Tools And Lawn And Garden Machinery – Safety – Part 3-13: Particular Requirements for Transportable Drills, issued February 2017. IEC 62841- 3-13 is copyrighted by the IEC.
This harmonized standard was prepared by CSA Group and Underwriters Laboratories Inc. (UL). The efforts and support of the International Harmonization Committee (IHC) for the adoption of the IEC series of standards for Hand-Held, Motor-Operated, and Transportable Tools and Lawn and Garden Machinery UL are gratefully acknowledged.
This standard is considered suitable for use for conformity assessment within the stated scope of the standard.
This standard was reviewed by the CSA Subcommittee on Safety of Hand-Held Motor-Operated Electric Tools, under the jurisdiction of the CSA Technical Committee on Consumer and Commercial Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group.
This standard has been approved by the American National Standards Institute (ANSI) as an American National Standard.
This clause of Part 1 is applicable, except as follows:
This part of IEC 62841 applies to transportable drills, with manually fed axial movement of the spindle, having a maximum chuck capacity of 13 mm.
NOTE 101 Transportable drills are also known as bench drills or drill presses.
This part of IEC 62841 does not apply to stationary drilling machines.
This part of IEC 62841 does not apply to radial arm drills.
This part of IEC 62841 does not apply to magnetic drill stands and drill motors.
NOTE 102 Magnetic drill stands and drill motors will be covered by a future part of IEC 62841-3.
NOTE 103 In Europe (EN 62841-3-13), the following conditions apply:
Radial arm drills and stationary drilling machines are covered by EN 12717.
Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery – Safety – Part 3-13: Particular requirements for transportable drills (Binational standard with UL 62841-3-13)
Outils électroportatifs à moteur, outils portables et machines pour jardins et pelouses — Sécurité — Partie 3-13 : Exigences particulières pour les perceuses transportables (norme binationale avec UL 62841-3-13)