Overview

Definitions for Hazardous Locations

In North America, hazardous locations have traditionally been defined by a combination of classes and divisions or zones as follows:

Classes

  • Class I – A location made hazardous by the presence of flammable gases or vapours that may be present in the air in quantities sufficient to produce an explosive or ignitable mixture
  • Class II – A location made hazardous by the presence of combustible or electrically conductive dust
  • Class III – A location made hazardous by the presence of easily ignitable fibers or flyings in the air, but not likely to be in suspension in quantities sufficient to produce ignitable mixtures

Divisions

  • Division 1 – A location where a classified hazard exists or is likely to exist under normal conditions
  • Division 2 – A location where a classified hazard does not normally exist but is possible to appear under abnormal conditions

North American Transition to the Zone System

The U.S and Canada have recently revised installation codes to recognise an international 3 Zone area classification system for equipment used in hazardous locations. This 3 Zone system is almost directly aligned with the current European system for area classification. Products certified for use in this 3 Zone system need to be compliant with the same standards used for IECEx and ATEX certification (IEC/EN 60079) with some national deviations.

  • Zone 0 – An area in which an explosive gas atmosphere is continuously present for a long period of time
  • Zone 1 – An area in which an explosive atmosphere is likely to occur in normal operation
  • Zone 2 – An area in which an explosive gas atmosphere does not normally exist

In Canada, all new installations must use the 3 Zone system. Existing installations may continue to use the 2 Division system or opt to re-classify using the 3 Zone system.

In the U.S, all installations (both new and existing) can either continue using the 2 Division system or re-classify using the 3 Zone system.

Explore more about CSA Group

Learn more about the CSA Group

How Do I Get My Product Approved for North America? right-arrow

When exporting equipment to Europe, a manufacturer can make a self-declaration...

The CSA North American Mark right-arrow

When selling your products into North America, you can use a CSA mark as your certification...